ZyXEL Communications GS1900-10HP - The Edit IGMP Screen

Chapter 26 Configuration: Multicast
GS1900 Series User’s Guide
163
26.2.3 The Edit IG MP Sc re e n
Use this screen to configure the IG MP VLAN settings. Click C o nfig ura tio n > Multic a st > IGMP > VLAN > Edit
to open this screen.
Fig ure 162 Configuration > Multicast > IGMP > VLAN > Edit
The following table describes the labels in this screen.
Table 109 Configuration > Multicast > IGMP > VLAN > Edit
LABEL DESCRIPTIO N
IGMP Edit
VLAN List Enter the ID of a static VLAN; the valid range is between 1 and 4094.
IGMP State Select the status of the VLAN to Ena ble or Disa b le the function.
Router Ports Auto
Learn
Select Ena ble d to have the Switch learn multicast router membership information of any VLANs
automatically.
Query Retry Enter the number of query retry times. The value can be between 1 and 7.
Query Interval Enter the amount of time (in seconds) between general query messages sent by the router
connected to the upstream port. The value can be between 30 and 18000.
Query Max.
Response
Interval
Enter the amount of time (in seconds) the router connected to the upstream port waits for a
response to an IGMP general query message.
Last Member
Query Count
Enter the number of queries.
Last Member
Query Interval
Enter the amount of time (in seconds) between the IGMP group-specific queries sent by an
upstream port when an IGMP Done message is received.
IGMP Querier
State
Select the IGMP querier status to Ena ble or Disa b le the function.
IGMP Querier
Version
Select the IGMP Querier version to v2 or v3.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.