Chapter 13 Spanning Tree Protocol
GS1920 Series User’s Guide
131
Figure 97 Advanced Application > Spanning Tree Protocol > MSTP
The following table describes the labels in this screen.
Table 52 Advanced Application > Spanning Tree Protocol > MSTP
LABEL DESCRIPTION
Port Click Port to display the MSTP Port screen (see Figure 98 on page 134).
Status Click Status to display the MSTP Status screen (see Figure 99 on page 135).
Active Select this to activate MSTP on the Switch. Clear this to disable MSTP on the Switch.
Note: You must also activate Multiple Spanning Tree in the Advanced Application >
Spanning Tree Protocol > Configuration screen to enable MSTP on the Switch.
Hello Time This is the time interval in seconds between BPDU (Bridge Protocol Data Units)
configuration message generations by the root switch. The allowed range is 1 to 10
seconds.
To Next Page
Loading...
