Chapter 33 Link Layer Discovery Protocol (LLDP)
GS1920 Series User’s Guide
289
The following table describes the labels in this screen.
33.6.2 LLDP Configuration Org-specific TLV Setting
Use this screen to configure organization-specific TLV settings. Click Advanced Application >
LLDP > LLDP Configuration (Click Here) > Org-specific TLV Setting to display the screen as
shown next.
Table 135 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL DESCRIPTION
Port This displays the Switch’s port number.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Management
Address
Select the check box(es) to enable or disable the sending of Management Address TLVs
on the port(s).
Port Description Select the check box(es) to enable or disable the sending of Port Description TLVs on the
port(s).
System
Capabilities
Select the check box(es) to enable or to disable the sending of System Capabilities TLVs
on the port(s).
System
Description
Select the check box(es) to enable or to disable the sending of System Description TLVs
on the port(s).
System Name Select the check box(es) to enable or to disable the sending of System Name TLVs on the
port(s).
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
