Chapter 36 DHCP
GS1920 Series User’s Guide
311
Figure 217 DHCP Relay Configuration Example
36.4.6 Configuring DHCPv4 VLAN Settings
Use this screen to configure your DHCP settings based on the VLAN domain of the DHCP clients.
Click IP Application > DHCP > DHCPv4 in the navigation panel, then click the VLAN link In the
DHCP Status screen that displays.
Note: You must set up a management IP address for each VLAN that you want to
configure DHCP settings for on the Switch. See Section 5.2 on page 43 for
information on how to do this.
Figure 218 IP Application > DHCP > DHCPv4 > VLAN
The following table describes the labels in this screen.
Table 152 IP Application > DHCP > DHCPv4 > VLAN
LABEL DESCRIPTION
VID Enter the ID number of the VLAN to which these DHCP settings apply.
Remote DHCP
Server 1 .. 3
Enter the IP address of a DHCP server in dotted decimal notation.
Option 82
Profile
Select a pre-defined DHCP option 82 profile that the Switch applies to all ports in this VLAN.
The Switch adds the Circuit ID sub-option and/or Remote ID sub-option specified in the
profile to DHCP requests that it relays to a DHCP server.
To Next Page
Loading...
