Chapter 33 Link Layer Discovery Protocol (LLDP)
GS1920 Series User’s Guide
293
The following table describes the labels in this screen.
33.9 LLDP-MED Location
Click Advanced Application > LLDP > LLDP-MED Location (Click Here) to display the screen
as shown next.
Table 138 Advanced Application > LLDP > LLDP-MED Network Policy
LABEL DESCRIPTION
Port Enter the port number to set up the LLDP-MED network policy.
Application Type Select the type of application used in the network policy.
•voice
• voice-signaling
• guest-voice
• guest-voice-signaling
• softphone-voice
• video-conferencing
•streaming-video
• video-signaling
Tag Select to tag or untag in the network policy.
• tagged
• untagged
VLAN Enter the VLAN ID number. It should be from 1 to 4094. For priority tagged frames, enter
“0”.
DSCP Enter the DSCP value of the network policy. The value is defined from 0 through 63 with
the 0 representing use of the default DSCP value.
Priority Enter the priority value for the network policy.
Add Click Add after finish entering the network policy information. A summary table will list
all the Switch you’ve added.
Cancel Click Cancel to begin entering the information afresh.
Index This field displays the of index number of the network policy. Click an index number to
edit the rule.
Port This field displays the port number of the network policy.
Application Type This field displays the application type of the network policy.
Tag This field displays the Tag Status of the network policy.
VLAN This field displays the VLANID of the network policy.
Priority This field displays the priority value of the network policy.
DSCP This field displays the DSCP value of the network policy.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Delete Check the rules that you want to remove, then click the Delete button.
Cancel Click Cancel to clear the selected check boxes.
To Next Page
Loading...
