GS1920 Series User’s Guide
62
CHAPTER 8
Basic Setting
8.1 Overview
This chapter describes how to configure the System Info, General Setup, Switch Setup, IP
Setup, Port Setup, PoE, Interface Setup and IPv6 screens.
8.1.1 What You Can Do
•Use the System Info screen (Section 8.2 on page 62) to check the firmware version number.
•Use the General Setup screen (Section 8.3 on page 64) to configure general settings such as
the system name and time.
•Use the Switch Setup screen (Section 8.5 on page 67) to choose your VLAN type, set the GARP
timers and assign priorities to queues.
•Use the IP Setup screen (Section 8.6 on page 68) to configure the Switch IP address, default
gateway device, and the management VLAN ID.
•Use the Port Setup screen (Section 8.7 on page 70) to configure Switch port settings.
•Use the PoE Status screens (Section 8.8 on page 72) to view the current amount of power that
PDs are receiving from the Switch and set the priority levels for the Switch in distributing power
to PDs. This screen is available for PoE model(s) only.
•Use the Interface Setup screens (Section 8.9 on page 77) to configure Switch interface type
and interface ID settings.
•Use the IPv6 screens (Section 8.10 on page 78) to view IPv6 status and IPv6 configuration.
•Use the DNS screen (Section 8.11 on page 90) to configure the default domain name server.
8.2 System Information
In the navigation panel, click Basic Setting > System Info to display the screen as shown. Use
this screen to view general system information. You can check the firmware version number.
To Next Page
Loading...
