ZyXEL Communications GS2200 Series - Link Aggregation Setting

Chapter 17 Link Aggregation
GS2200 Series User’s Guide
134
17.3 Link Aggregation Setting
Click Advanced Application > Link Aggregation > Link Aggregation Setting to display the
screen shown next. See Section 17.1 on page 131 for more information on link aggregation.
Figure 86 Advanced Application > Link Aggregation > Link Aggregation Setting
The following table describes the labels in this screen.
Table 43 Advanced Application > Link Aggregation > Link Aggregation Setting
LABEL DESCRIPTION
Link
Aggregation
Setting
This is the only screen you need to configure to enable static link aggregation.
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple
ports.
Active Select this option to activate a trunk group.