ZyXEL Communications GS2200 Series - Link Aggregation Control Protocol

Chapter 17 Link Aggregation
GS2200 Series User’s Guide
136
17.4 Link Aggregation Control Protocol
Click Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to
display the screen shown next. See Dynamic Link Aggregation on page 131 for more information on
dynamic link aggregation.
Figure 87 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Table 44 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL DESCRIPTION
Link
Aggregation
Control
Protocol
Note: Do not configure this screen unless you want to enable dynamic link aggregation.
Active Select this checkbox to enable Link Aggregation Control Protocol (LACP).