ZyXEL Communications GS2200 Series - Configuring SNMP

Chapter 35 Access Control
GS2200 Series User’s Guide
256
Click Management > Access Control in the navigation panel to display the main screen as
shown.
Figure 171 Management > Access Control
35.3 Configuring SNMP
Use this screen to configure your SNMP settings.
Click Management > Access Control > SNMP to view the screen as shown.
Figure 172 Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 105 Management > Access Control > SNMP
LABEL DESCRIPTION
General Setting Use this section to specify the SNMP version and community (password) values.
Version Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or
both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP version 1.