GS2200 Series User’s Guide 60
CHAPTER 8
Basic Setting
8.1 Overview
This chapter describes how to configure the System Info, General Setup, Switch Setup, IP
Setup, Port Setup, and PoE screens.
8.1.1 What You Can Do
•Use the System Info screen (Section 8.2 on page 61) to check the firmware version number.
•Use the General Setup screen (Section 8.3 on page 63) to configure general settings such as
the system name and time.
•Use the Switch Setup screen (Section 8.5 on page 65) to choose your VLAN type, set the ARP
aging time and GARP timers and assign priorities to queues.
•Use the IP Setup screen (Section 8.6.1 on page 67) to configure the Switch IP address, default
gateway device, the default domain name server and the management VLAN ID.
•Use the Port Setup screen (Section 8.7 on page 69) to configure Switch port settings.
•Use the PoE Status screen (Section 8.8 on page 70) to view the current amount of power that
PDs are receiving from the Switch and use the PoE Setup screen (Section 8.8.1 on page 73) to
set the priority levels for the Switch in distributing power to PDs. (These screens are available to
GS2200-8HP and GS2200-24P only.)
To Next Page
Loading...
