Chapter 24 AAA
GS2200 Series User’s Guide
180
24.4 TACACS+ Server Setup
Use this screen to configure your TACACS+ server settings. See Section on page 177 for more
information on TACACS+ servers. Click on the TACACS+ Server Setup link in the AAA screen to
view the screen as shown.
Figure 118 Advanced Application > AAA > TACACS+ Server Setup
The following table describes the labels in this screen.
Table 63 Advanced Application > AAA > TACACS+ Server Setup
LABEL DESCRIPTION
Authentication
Server
Use this section to configure your TACACS+ authentication settings.
Mode This field is only valid if you configure multiple TACACS+ servers.
Select index-priority and the Switch tries to authenticate with the first configured
TACACS+ server, if the TACACS+ server does not respond then the Switch tries to
authenticate with the second TACACS+ server.
Select round-robin to alternate between the TACACS+ servers that it sends
authentication requests to.
Timeout Specify the amount of time in seconds that the Switch waits for an authentication request
response from the TACACS+ server.
If you are using index-priority for your authentication and you are using two TACACS+
servers then the timeout value is divided between the two TACACS+ servers. For
example, if you set the timeout value to 30 seconds, then the Switch waits for a response
from the first TACACS+ server for 15 seconds and then tries the second TACACS+ server.
Index This is a read-only number representing a TACACS+ server entry.
IP Address Enter the IP address of an external TACACS+ server in dotted decimal notation.
To Next Page
Loading...
