Chapter 2 Hardware Installation and Connection
GS2200-8/24 User’s Guide
24
2 Align the holes on the back of the Switch with the screws on the wall. Hang the Switch on the
screws.
Figure 7 Wall-mounting Example
The Switch should be wall-mounted horizontally. The Switch's side
panels with ventilation slots should not be facing up or down as this
position is less safe.
The following are dimensions of a self-tapping screw and masonry plug used for wall mounting. All
measurements are in millimeters (mm).
Figure 8 Masonry Plug and 3.5 mm Self-Tapping Screw
To Next Page
Loading...
