ZyXEL Communications NBG-416N - 12.4 General Firewall Screen

Chapter 12 Firewall
NBG-416N User’s Guide
111
12.4 General Firewall Screen
Use this screen to enable or disable the NBG-416N’s firewall, and set up firewall
logs. Click Security > Firewall to open the General screen.
Figure 65 Security > Firewall > General
The following table describes the labels in this screen.
12.5 Services Screen
Use the Services screen to enable or disable ICMP and VPN passthrough features.
Click Security > Firewall > Services. The screen appears as shown next.
Figure 66 Security > Firewall > Services
Table 43 Security > Firewall > General
LABEL DESCRIPTION
Enable Firewall Select this check box to activate the firewall. The NBG-416N performs
access control and protects against Denial of Service (DoS) attacks
when the firewall is activated.
Apply Click Apply to save the settings.
Reset Click Reset to start configuring this screen again.