ZyXEL Communications NBG-416N - 6.3 Enable and Configure Wireless Security without WPS on your NBG-416 N

Chapter 6 Tutorials
NBG-416N User’s Guide
61
6.3 Enable and Configure Wireless Security
without WPS on your NBG-416N
This example shows you how to configure wireless security settings with the
following parameters on your NBG-416N.
Follow the steps below to configure the wireless settings on your NBG-416N.
The instructions require that your hardware is connected (see the Quick Start
Guide) and you are logged into the Web Configurator through your LAN connection
(see Section 3.2 on page 25).
1 Open the Wireless LAN > General screen in the NBG-416N’s Web Configurator.
2 Make sure the Enable Wireless LAN check box is selected.
3 Enter SSID_Example3 as the SSID and select a channel.
4 Set security mode to WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in
the Pre-Shared Key field. Click Apply.
Figure 32 Tutorial: Network > Wireless LAN > General
SSID SSID_Example3
Channel 6
Security WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)