Chapter 3 The Web Configurator
NBG-416N User’s Guide
27
• Select a language to go to the basic Web Configurator in that language. To
change to the advanced configurator see Chapter 19 on page 143.
Figure 5 Selecting the setup mode
3.3 Resetting the NBG-416N
If you forget your password or IP address, or you cannot access the Web
Configurator, you will need to use the RESET button at the back of the NBG-416N
to reload the factory-default configuration file. This means that you will lose all
configurations that you had previously saved, the username will be reset to
admin and password will be reset to 1234. The IP address will be reset to
“192.168.1.1”.
3.3.1 Using the RESET Button
1 Make sure the power LED is on.
2 Press the RESET button for longer than 1 second to restart/reboot the NBG-416N.
3 Press the RESET button for longer than five seconds to set the NBG-416N back to
its factory-default configurations.
3.4 Navigating the Web Configurator
The following summarizes how to navigate the Web Configurator from the Status
screen in Router Mode and AP Mode.
To Next Page
Loading...
