Chapter 13 Remote Management
NBG-416N User’s Guide
115
13.3 WWW Screen
To change your NBG-416N’s World Wide Web settings, click Management >
Remote MGMT to display the WWW screen.
Figure 67 Management > Remote MGMT > WWW
The following table describes the labels in this screen.
Table 45 Management > Remote MGMT > WWW
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed,
however you must use the same port number in order to use that
service for remote management.
Server Access Select the interface(s) through which a computer may access the
NBG-416N using this service.
Secured Client IP
Address
A secured client is a “trusted” computer that is allowed to
communicate with the NBG-416N using this service.
Select All to allow any computer to access the NBG-416N using
this service.
Choose Selected to just allow the computer with the IP address
that you specify to access the NBG-416N using this service.
Note: This only applies on WAN IP.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
