Chapter 10 DHCP Server
NBG-416N User’s Guide
98
10.6 Client List Screen
The DHCP table shows current DHCP client information (including IP Address,
Host Name and MAC Address) of network clients using the NBG-416N’s DHCP
servers.
Configure this screen to always assign an IP address to a MAC address (and host
name). Click Network > DHCP Server > Client List.
Note: You can also view a read-only client list by clicking the DHCP Table (Details...)
hyperlink in the Status screen.
The following screen displays.
Figure 58 Network > DHCP Server > Client List
First DNS Server
Second DNS
Server
Select User-Defined if you have the IP address of a DNS server.
Enter the DNS server's IP address in the field to the right. If you chose
User-Defined, but leave the IP address set to 0.0.0.0, User-Defined
changes to None after you click Apply. If you set a second choice to
User-Defined, and enter the same IP address, the second User-
Defined changes to None after you click Apply.
Select DNS Relay to have the NBG-416N act as a DNS proxy. The
NBG-416N's LAN IP address displays in the field to the right (read-
only). The NBG-416N tells the DHCP clients on the LAN that the NBG-
416N itself is the DNS server. When a computer on the LAN sends a
DNS query to the NBG-416N, the NBG-416N forwards the query to the
NBG-416N's system DNS server (configured in the WAN > Internet
Connection screen) and relays the response back to the computer.
You can only select DNS Relay for one of the three servers; if you
select DNS Relay for a second or third DNS server, that choice
changes to None after you click Apply.
Apply Click Apply to save your changes back to the NBG-416N.
Reset Click Reset to begin configuring this screen afresh.
Table 38 Network > DHCP Server > Advanced (continued)
LABEL DESCRIPTION
To Next Page
Loading...
