ZyXEL Communications NBG-416N - Summary: DHCP Table

Chapter 3 The Web Configurator
NBG-416N User’s Guide
32
3.5.2 Summary: DHCP Table
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows
individual clients to obtain TCP/IP configuration at start-up from a server. You can
configure the NBG-416N’s LAN as a DHCP server or disable it. When configured as
a server, the NBG-416N provides the TCP/IP configuration for the clients. If DHCP
service is disabled, you must have another DHCP server on that network, or else
the computer must be manually configured.
Click the DHCP Table (Details...) hyperlink in the Status screen. Read-only
information here relates to your DHCP status. The DHCP table shows current
DHCP client information (including IP Address, Host Name and MAC Address)
of all network clients using the NBG-416N’s DHCP server.
Figure 7 Summary: DHCP Table
The following table describes the labels in this screen.
Tools Firmware Use this screen to upload firmware to your NBG-416N.
Configuration Use this screen to backup and restore the configuration or
reset the factory defaults to your NBG-416N.
Restart This screen allows you to reboot the NBG-416N without
turning the power off.
Sys OP
Mode
General This screen allows you to select whether your device acts
as a Router or a Access Point.
Language Language This screen allows you to select the language you prefer.
Table 4 Screens Summary (continued)
LINK TAB FUNCTION
Table 5 Summary: DHCP Table
LABEL DESCRIPTION
# This is the index number of the host computer.
IP Address This field displays the IP address relative to the # field listed above.
Host Name This field displays the computer host name.