NBG-416N User’s Guide
145
CHAPTER 20
Troubleshooting
This chapter offers some suggestions to solve problems you might encounter. The
potential problems are divided into the following categories.
• Power, Hardware Connections, and LEDs
• NBG-416N Access and Login
• Internet Access
• Resetting the NBG-416N to Its Factory Defaults
• Wireless Router/AP Troubleshooting
20.1 Power, Hardware Connections, and LEDs
The NBG-416N does not turn on. None of the LEDs turn on.
1 Make sure you are using the power adaptor or cord included with the NBG-416N.
2 Make sure the power adaptor or cord is connected to the NBG-416N and plugged
in to an appropriate power source. Make sure the power source is turned on.
3 Disconnect and re-connect the power adaptor or cord to the NBG-416N.
4 If the problem continues, contact the vendor.
One of the LEDs does not behave as expected.
1 Make sure you understand the normal behavior of the LED. See Section 1.5 on
page 20.
2 Check the hardware connections. See the Quick Start Guide.
To Next Page
Loading...
