Chapter 5 Storage
NSA-220 Plus User’s Guide
118
The following table describes the labels in this screen.
5.5 Creating an External Volume
Click the Create a New External Volume button in the Storage screen as
shown in Figure 21 on page 113 to open the following screen. Use this screen to
create a new NSA external disk drive volume.
Note: Creating a volume formats the drive. All data on the disk will be lost.
Figure 25 Storage > Create an External Volume
Table 18 Storage > Edit
LABEL DESCRIPTION
Volume Name For an internal volume, type a volume name from 1 to 31
characters. To avoid confusion, it is highly recommended that
each volume use a unique name.
Acceptable characters are all alphanumeric characters and " "
[spaces], "_" [underscores], and "." [periods].
The first character must be alphanumeric (A-Z 0-9).
The last character cannot be a space " ".
For an external volume, type a volume name from 1 to 32
single-byte (no Chinese characters allowed for example) ASCII
characters. The name cannot be the same as another existing
external volume.
Apply Click this to save your changes and rename the volume.
Cancel Click this to close this screen without saving your changes.
To Next Page
Loading...
