ZyXEL Communications NSA-220 Plus - Configuring the TCP;IP Screen

Chapter 6 Network
NSA-220 Plus User’s Guide
127
6.2.2 Configuring the TCP/IP Screen
Click Network > TCP/IP in the navigation panel to open the following screen.
Note: If you change the NSA’s IP address, you need to log in again after you apply
changes.
Figure 27 Network > TCP/IP
The following table describes the labels in this screen.
Table 24 Network > TCP/IP
LABEL DESCRIPTION
IP Address
Dynamic Select this option to have the NSA get IP address information
automatically.
If no IP address information is assigned, the NSA uses Auto-IP to
assign itself an IP address and subnet mask. For example, you could
connect the NSA directly to your computer. If the computer is also set
to get an IP address automatically, the computer and the NSA will
choose addresses for themselves and be able to communicate.
Static Select this option for the NSA to use fixed TCP/IP information. You
must fill in the following fields.
IP Address Type an IP address in this field.