Chapter 7 Applications
NSA-220 Plus User’s Guide
134
The following table describes the labels in this screen.
Table 26 Applications > FTP
LABEL DESCRIPTION
FTP
Enable FTP You can use FTP to send files to the NSA or get files from the NSA.
Select this check box to allow users to connect to the NSA via FTP;
otherwise clear the check box.
Connection Limit Enter the maximum number of concurrent FTP connections allowed
on the NSA in this field.
Idle Timeout Enter the length of time that an FTP connection can be idle before
timing out.
Enable Anonymous
FTP Access
Select this check box to allow any user to log into the NSA using
‘FTP’ or ‘anonymous’ as a username and no password. Any other
name is considered a username, so must be valid and have a
corresponding correct password.
Customize the port
range for data
transfer
Select this check box to assign a port range for FTP clients to use
when downloading files from the NSA using passive mode.
The connection limit is restricted to half of the port numbers within
the range if this value is smaller than the one configured in the
Connection Limit field. For example, you specified a port range
from 1024 to 1029 and configured 10 in the Connection Limit
field. The FTP connection limit will only be 3 (6 ports in the range
divided by 2) because it is the smaller value.
Starting Port Enter the first port number in the range. Choose from 1024 to
65535.
Ending Port Enter the last port number in the range. Choose from 1024 to
65535.
Character Set The NSA uses UTF-8 (8-bit UCS/Unicode Transformation Format)
format for FTP by default. If the NSA’s folders, or file names do not
display correctly in your FTP client, select the appropriate language
encoding here.
This setting applies to all FTP client connections to the NSA. It does
not affect your Windows/CIFS connections (it will not correct the
character display in Windows Explorer).
Apply Click this to save your changes.
Reset Click this to restore your previously saved settings.
To Next Page
Loading...
