Chapter 8 Package Management
NSA-220 Plus User’s Guide
214
Click Protect > Backup to open the following screen.
Figure 90 Protect > Backup
The following table describes the labels in this screen.
Table 65 Protect > Backup
LABEL DESCRIPTION
Backup
Add Job Click this to create and customize a backup job.
Edit Job Select a backup job in the list and click this to make some changes to
it.
Delete Selected
Job(s)
Select a backup job in the list and click this to delete it.
Execute Job Now Select a backup job in the list and click this to run the backup job
immediately.
Restore Archive Select a backup job in the list and click this to restore the file(s)
included in that backup job to the NSA.
This applies to Archive backups only. Refer to Section 8.10.8 on page
226 to see the screens.
Abort Job Select a backup job in the list and click this to stop the process if the
backup job is currently active.
Status This shows the current state of the backup job.
• Waiting means the backup job is not active but is scheduled to
run at some time.
• Running indicates that the NSA is currently doing the backup job.
When the backup job is running, you can also see a progress bar.
Job Name This identifies the backup job.
Job Description This is a short description of the backup job.
Backup Info This lists down the backup job details: type, source and target. Refer
to Section 8.10.1 on page 215 and Section 8.10.2 on page 217.
Scheduler Info This shows the backup schedule, including the frequency, the time it
was last run in (and whether or not it succeeded), and when it is
scheduled to run again. The times use yyyy-mm-dd hh:mm:ss
format.
Refer to Section 8.10.4 on page 221.
To Next Page
Loading...
