ZyXEL Communications NXC2500 - Set Mirror Port on Switch; Capture Wireless Packets; Capture with WLAN Controller and Managed AP

10/124
www.zyxel.com
Winpcap is also bundled with Wireshark.
The new Win10pcap is able to capture packets with 802.1Q VLAN tags:
http://www.win10pcap.org/
Win10pcap supports only Win7 and later windows system.
2.1.4 Set Mirror Port on Switch
Select the source port, destination port, and the flow direction, then
connect the capture device to the destination port and start capture.
2.2 Capture Wireless Packets
2.2.1 Capture with WLAN Controller and Managed AP
1 Set up a MON profile on controller.
Figure 14 CONFIGURATION > Object > MON Profile > MON Profile > Edit
2 Set ‘Scan Channel Mode’ to manual, and select the channel you want to
capture packets.
Figure 15 CONFIGURATION > Object > MON Profile > MON Profile > Edit