Figure 170 Tera Term > AP > Router> show wlan slot1 list all sta
7.3 The Limitation of roaming
“Band Select” may potentially cause interruptions for time-sensitive
applications because of roaming delays
The connection might be not stable if the “Load Balance” is enabled
and the station number is reached to the maximum number. The
roaming station may connect to the AP and disconnection soon.
To set the threshold in radio might cause disconnection between AP
and station. When the overlap area RSSI is lower than threshold value,
station is not able to connect to AP.
7.4 Symptom: Why station can’t connect to the AP2
If the station can’t connect to AP2 when roaming, please follow the steps to
troubleshooting.
1. Check AP2’s the SSID, Security, and DHCP server are the same as AP1.
2. Check radio threshold
3. Does station always connect to AP1?
1 Check AP2’s the SSID, Security, and DHCP server are the same as AP1
If using the controller to control managed APs, it’s better to make AP1 and
AP2 in the same AP group that has the same SSID and security.
AP1 and AP2 should use the same DHCP server and in the same subnet.
NXC
Use AP group to set the same configuration for AP1 and AP2.
Figure 171 CONFIGURATION > Wireless > AP Management > AP Group >
Radio1 Setting
To Next Page
Loading...
