Figure 168 Configuration > Wireless > AP Management > Mgnt. AP List > Edit
AP List > Radio1 Setting
Checking the APs coverage range should overlap. (You may use the
application to scan the signal, like inSSIDer)
Figure 169 inSSIDer
The station usually disconnect with AP when the RSSI lower than -60dBm, so
the overlapping edge should not lower than -60dBm to avoid signal too
weak for connection.
We can check the RSSI of connected station on AP by CLI.
Signal strength = RSSI-95 (ex. 59-95= -36dBm)
To Next Page
Loading...
