Display all wireless interfaces on station and Access Point.
Figure 132 Laptop> cmd > netsh wlan show interface all
The station list info of associated AP:
Figure 133 MONITOR > Wireless > Station Info
5.3 Symptom: Wireless low throughput
There are some information you have to know from customer and follow the
order of the questions you will know how to troubleshooting.
The procedure of the troubleshooting:
1. Check the configuration of the controller (USG/ ZyWALL/ NXC).
2. Environment Verification
3. Information collection and report the issue to the HQ.
If you don’t know how to do above the question and steps, please keep
reading.
1 Check the configuration of controller (USG/ ZyWALL/ NXC).
Clarify the client can get the IP address or not.
Check the configuration which was setup the rate limited or not.
To Next Page
Loading...
