3 Check packets via CLI on controller.
Figure 12 Tera Term > NXC > Router# packet-trace interface <interface>
Press “Ctrl+c” to end of packets capturing.
2.1.2 Use AP CLI (AP cannot save captured packets)
Check packets via CLI on AP.
Figure 13 Tera Term > NXC > Router# packet-trace interface vlan0
Press “Ctrl+c” to end of packets capturing.
Note: ‘vlan0’ is an example of interface you want to capture packets with.
Add port or ip-proto, src-host, dst-host to the command to filter the
captured result.
The saved captured files can be downloaded via GUI or FTP.
2.1.3 Use PC
Capture the packet on PC should install some software. For example:
Windows needs to install Winpcap first: http://www.winpcap.org/
Download Wireshark at: https://www.wireshark.org/
To Next Page
Loading...
