3 Check the configuration of the NXC.
If the NXC controller is not a gateway, please check the interface for station
doing captive portal whether write the gateway IP address.
Assume the stations in the VLAN10 must blocked by captive portal. The
interface VLAN10 in the NXC controller must write the correct gateway IP
address, otherwise; the NXC cannot redirect the correct captive portal
page.
Figure 139 CONFIGURATION > Network > VLAN > VLAN10 > IP Address
Assignment
There are two types for user to set the authentication policy – Redirect on
controller and Redirect on AP.
Note: Do not enable captive portal redirect on the NXC controller and on
the Managed AP simultaneously.
Redirect on controller
Enable the function of Captive Portal.
Figure 140 CONFIGURATION > Captive Portal > Captive Portal
To Next Page
Loading...
