Chapter 7 Wireless LAN
PLA5236 User’s Guide
39
7.5.3 WPA-PSK/WPA2-PSK
Select WPA-PSK or WPA2-PSK from the Security Mode list.
Figure 22 Network > Wireless LAN 2.4G or 5G > Security: WPA2-PSK
Hex Select this option in order to enter hexadecimal characters as a WEP key.
The preceding "0x", that identifies a hexadecimal key, is entered automatically.
Key 1 to Key 4 The WEP keys are used to encrypt data. Both the PLA and the wireless stations must use the
same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal characters ("0-9",
"A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters ("0-9",
"A-F").
You must configure at least one key, only one key can be activated at any one time. The
default key is key 1.
Apply Click Apply to save your changes back to the PLA.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 15 Network > Wireless LAN 2.4G or 5G > Security: Static WEP
LABEL DESCRIPTION
To Next Page
Loading...
