Chapter 7 Wireless LAN
PLA5236 User’s Guide
43
Figure 25 Network > Wireless LAN 2.4G or 5G > QoS
The following table describes the labels in this screen.
7.9 WPS Screen
Use this screen to enable/disable WPS, view or generate a new PIN number and check current WPS
status. To open this screen, click Network > Wireless LAN 2.4G or 5G > WPS tab.
Figure 26 Network > Wireless LAN 2.4G or 5G > WPS
Table 19 Network > Wireless LAN 2.4G or 5G > QoS
LABEL DESCRIPTION
WMM QoS Select Enable to have the PLA automatically give a service a priority level according to
the ToS value in the IP header of packets it sends. WMM QoS (Wifi MultiMedia Quality of
Service) gives high priority to voice and video, which makes them run more smoothly.
Note: If you select 802.11n, 802.11gn or 802.11bgn in the Wireless LAN 2.4G or
5G> General screen, this field is not configurable and the PLA
automatically enables WMM QoS.
Apply Click Apply to save your changes to the PLA.
Cancel Click Cancel to reload the previous configuration for this screen.
To Next Page
Loading...
