Chapter 11 Maintenance
PLA5236 User’s Guide
56
The following table describes the labels in this screen.
11.4 Password Screen
It is strongly recommended that you change your PLA's password.
If you forget your PLA's password (or IP address), you will need to reset the device. See Section 11.8 on
page 61 for details
Click Maintenance > Password.
Figure 36 Maintenance > Password
The following table describes the labels in this screen.
11.5 Time Setting Screen
Use this screen to configure the PLA’s time based on your local time zone. To change your PLA’s time
and date, click Maintenance > Time. The screen appears as shown.
Table 26 Maintenance > General
LABEL DESCRIPTION
Administrator
Inactivity Timer
Type how many minutes a management session can be left idle before the session times out.
The default is 5 minutes. After it times out you have to log in with your password again. Very
long idle timeouts may have security risks. A value of "0" means a management session
never times out, no matter how long it has been left idle (not recommended).
Apply Click Apply to save your changes back to the PLA.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 27 Maintenance > Password
LABEL DESCRIPTION
Old Password Type the default password or the existing password you use to access the system in this
field.
New Password Type your new system password (up to 30 characters). Note that as you type a password,
the screen displays an asterisk (*) for each character you type.
Retype to Confirm Type the new password again in this field.
Apply Click Apply to save your changes back to the PLA.
Cancel Click Cancel to reload the previous configuration for this screen.
To Next Page
Loading...
