ZyXEL Communications PLA5236 - WPS Station Screen

Chapter 7 Wireless LAN
PLA5236 User’s Guide
44
The following table describes the labels in this screen.
7.10 WPS Station Screen
Use this screen when you want to add a wireless station using WPS. To open this screen, click Network >
Wireless LAN 2.4G or 5G > WPS Station tab.
Figure 27 Network > Wireless LAN 2.4G or 5G > WPS Station
Table 20 Network > Wireless LAN 2.4G or 5G > WPS
LABEL DESCRIPTION
WPS Setup
WPS Select Enable to turn on the WPS feature. Otherwise, select Disable.
PIN Code Select Enable and click Apply to allow the PIN Configuration method. If you select Disable,
you cannot create a new PIN number.
PIN Number This is the WPS PIN (Personal Identification Number) of the PLA.
The PIN is not necessary when you use WPS push-button method.
Click Generate to generate a new PIN number.
WPS Status
Status This displays Configured when the PLA has connected to a wireless network using WPS or when
Enable WPS is selected and wireless or wireless security settings have been changed. The
current wireless and wireless security settings also appear in the screen.
This displays Unconfigured if WPS is disabled and there are no wireless or wireless security
changes on the PLA or you click Release_Configuration to remove the configured wireless
and wireless security settings.
Release
Configuration
This button is only available when the WPS status displays Configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the PLA.
802.11 Mode This is the 802.11 mode used. Only compliant WLAN devices can associate with the PLA.
SSID This is the name of the wireless network (the PLA’s first SSID).
Security This is the type of wireless security employed by the network.
Apply Click Apply to save your changes back to the PLA.
Cancel Click Cancel to reload the previous configuration for this screen.