Chapter 20 Web Authentication
ZyWALL USG Series User’s Guide
498
20.2.1.3 Set Up User Authentication Using the RADIUS Server
This step sets up user authentication using the RADIUS server. First, configure the settings for the RADIUS
server. Then, set up the authentication method, and configure the Zyxel Device to use the
authentication method. Finally, force users to log into the Zyxel Device before it routes traffic for them.
1 Click Configuration > Object > AAA Server > RADIUS. Double-click the radius entry. Configure the RADIUS
server’s address, authentication port (1812 if you were not told otherwise), and key. Click OK.
Figure 358 Configuration > Object > AAA Server > RADIUS > Add
2 Click Configuration > Object > Auth. Method. Double-click the default entry. Click the Add icon. Select
group radius because the Zyxel Device should use the specified RADIUS server for authentication. Click
OK.
To Next Page
Loading...
