Chapter 38 IDP
ZyWALL USG Series User’s Guide
715
38.2 The IDP Profile Screen
An IDP profile is a set of packet inspection signatures.
Click Configuration > UTM Profile > IDP > Profile to open this screen. Use this screen to view registration
and signature information.
Note: You must register in order to update packet inspection signatures. See the Registration
screens.
If you try to enable IDP when the IDP service has not yet been registered, a warning screen displays and
IDP is not enabled.
Click on the icons to go to the OneSecurity website where there is guidance on configuration
walkthroughs, troubleshooting and other information.
Figure 501 Configuration > UTM Profile > IDP > Profile
The following table describes the fields in this screen.
Table 258 Configuration > UTM Profile > IDP > Profile
LABEL DESCRIPTION
Profile Management
Add Click Add to create a new profile. Select from the options in the box.
Edit Select an entry and click this to be able to modify it.
Remove Select an entry and click this to delete it.
References Select an entry and click References to open a screen that shows which settings use the
entry. Click Refresh to update information on this screen.
To Next Page
Loading...
