Chapter 22 Printer Manager
ZyWALL USG Series User’s Guide
546
22.2.4 Edit Printer Manager (Discover Printer)
Select an entry in the Printer Manager > General > Discover Printer screen and click the Edit icon to open
the following screen. Use this screen to modify the printer’s nickname and IP address.
Figure 386 Configuration > Hotspot > Printer Manager > General > Discover Printer: Edit
The following table describes the labels in this screen.
Table 191 Configuration > Hotspot > Printer Manager > General > Discover Printer: Edit
LABEL DESCRIPTION
General Settings
Nickname Type an optional friendly name for the printer. A nickname must begin with a letter and cannot
exceed 15 characters. Valid characters are [a-zA-Z0-9_-].
IP Address Assignment
Get
Automatically
Select this to make the printer a DHCP client and automatically get the IP address, subnet
mask, and gateway address from a DHCP server.
Use Fixed IP
Address
Select this if you want to specify the IP address, subnet mask, and gateway manually.
IP Address This field is enabled if you select Use Fixed IP Address.
Enter the IP address for the printer.
Subnet Mask This field is enabled if you select Use Fixed IP Address.
Enter the subnet mask of the printer in dot decimal notation. The subnet mask indicates what
part of the IP address is the same for all computers in the network.
Gateway This field is enabled if you select Use Fixed IP Address.
Enter the IP address of the gateway. The Zyxel Device sends packets to the gateway when it
does not know how to route the packet to its destination. The gateway should be on the same
network as the printer.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
