ZyXEL Communications USG60W - Add;Edit Trusted RADIUS Client; Notification > Mail Server

Chapter 44 System
ZyWALL USG Series User’s Guide
954
44.12.1 Add/Edit Trusted RADIUS Client
Click Configuration > System > Auth. Server to display the Auth. Server screen. Click the Add icon or an
Edit icon to display the following screen. Use this screen to create a new entry or edit an existing one.
Figure 679 Configuration > System > Auth. Server > Add/Edit
The following table describes the labels in this screen.
44.13 Notification > Mail Server
Use this screen to configure a mail server so you can receive reports and notification emails such as
when your password is about to expire. After you configure the screen, you can test the settings in
Maintenance > Diagnostics > Network Tool and then select Test Email Server. See Configuration > Log &
Report > Email Daily Report to configure what reports to send and to whom.
Click Configuration > System > Notification to display the Mail Server screen.
Table 384 Configuration > System > Auth. Server > Add/Edit
LABEL DESCRIPTION
Activate Select this check box to make this profile active.
Profile Name Enter a descriptive name (up to 31 alphanumerical characters) for identification purposes.
IP Address Enter the IP address of the RADIUS client that is allowed to exchange messages with the Zyxel
Device.
Netmask Enter the subnet mask of the RADIUS client.
Secret Enter a password (up to 64 alphanumeric characters) as the key to be shared between the
Zyxel Device and the RADIUS client.
The key is not sent over the network. This key must be the same on the external authentication
server and the Zyxel Device.
Description Enter the description of each server, if any. You can use up to 60 printable ASCII characters.
OK Click OK to save the changes.
Cancel Click Cancel to discard the changes.