Chapter 22 Printer Manager
ZyWALL USG Series User’s Guide
543
22.2.1 Add Printer Rule
Click the Add icon to open the following screen. Use this screen to add a new printer.
Figure 383 Configuration > Hotspot > Printer Manager > General: Add
The following table describes the labels in this screen.
22.2.2 Edit Printer Rule
Select an entry in the Printer Manager > General screen and click the Edit icon to open the following
screen. Use this screen to modify the printer’s settings. You can't click the Edit icon when the printer
status is sync fail or sync progressing.
Figure 384 Configuration > Hotspot > Printer Manager > General: Edit
Table 188 Configuration > Hotspot > Printer Manager > General: Add
LABEL DESCRIPTION
Enable Printer
Manager
Select this option to turn on this entry in order to allow the Zyxel Device to manage this printer.
IPv4 Address Enter an IPv4 address for the printer.
Description Enter a description of this printer. You can use alphanumeric and
()+,/:=?!*#@$_%-”
characters, and it can be up to 60 characters long.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
