ZyXEL Communications USG60W - Page 508

Chapter 20 Web Authentication
ZyWALL USG Series User’s Guide
508
• created an authentication policy in the Configuration > Web Authentication: General screen to
redirect the matched users to the Facebook page before they can have free Internet access.
Note: If you disable Facebook Wi-Fi or reset the Facebook page settings later, the Zyxel
Device automatically logs out existing users who have authenticated their connections
via Facebook Wi-Fi.
Click Configuration > Web Authentication and then select the Facebook Wi-Fi tab to display the
following screen. If your Zyxel Device is not registered at myZyxel, the screen displays this additional
message '3. Please register your device on portal.myZyxel.com to activate configure Facebook Wi-Fi.
Click here to check register status.'
Figure 369 Configuration > Web Authentication: Facebook Wi-Fi
The following table describes the labels in this screen.
Table 175 Configuration > Web Authentication: Facebook Wi-Fi
LABEL DESCRIPTION
Enable Facebook
Wi-Fi
Select the check box and click Apply to turn on Facebook Wi-Fi on the Zyxel Device.
Configure Click this button to open the Facebook Wi-Fi configuration screen in a new window, where you
can select the Facebook Page associated with your location and configure bypass mode and
session length.
Note: You should have registered your Zyxel Device with myZyxel before you can
click Configure to set up Facebook Wi-Fi on the Zyxel Device.
Reset FB Page Click this button to remove your Facebook Page setting.
Enable user idle
detection
Select this check box if you want the Zyxel Device to monitor how long each user
(authenticated via Facebook Wi-Fi) is idle (in other words, there is no traffic for this user).
User idle timeout Specify the User idle timeout between 1 and 60 minutes. The Zyxel Device automatically
disconnects a user (authenticated via Facebook Wi-Fi) from the network after a period of
inactivity.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.