Chapter 3 Hardware, Interfaces and Zones
ZyWALL USG Series User’s Guide
71
The following table describes the ports on the front panel.
The following table describes the ports on the USG2200-VPN/USG2200 front panel.
P5-P16
(WAN/
LAN))
Green Off There is no connection on this port.
On This port has a successful 10/100Mbps link.
Blinking The Zyxel Device is sending or receiving packets on this port.
Orange Off There is no connection on this port.
On This port has a successful 1000Mbps link.
Blinking The Zyxel Device is sending or receiving packets on this port.
P17-P18
(SFP+)
Link
Blue Off There is no connection on this port.
On This port has a successful 10Gbps link.
P17-P18
(SFP+)
ACT
Green Off There is no traffic on this port.
Blinking The Zyxel Device is sending or receiving packets on this port.
P17-P18
(10GE)
Link
Blue Off There is no connection on this port.
On This port has a successful 10Gbps link.
P17-P18
(10GE)
ACT
Green Off There is no traffic on this port.
Blinking The Zyxel Device is sending or receiving packets on this port.
Table 12 Front Panel Ports
LABEL DESCRIPTION
RESET Press the button in for about 5 seconds (or until the SYS LED starts to blink), then release it to
return the Zyxel Device to the factory defaults (password is 1234, LAN IP address 192.168.1.1
etc.)
CONSOLE You can use the console port to manage the Zyxel Device using CLI commands. You will be
prompted to enter your user name and password. See the Command Reference Guide for
more information about the CLI.
When configuring using the console port, you need a computer equipped with
communications software configured to the following parameters:
• Speed 115200 bps
• Data Bits 8
•Parity None
•Stop Bit 1
• Flow Control Off
USB Connect a storage device for system logs (see Maintenance > Diagnostics > System Log) and
storage (see Configuration > System > USB Storage).
P1 ~ P6 These are 1G RJ-45 Ethernet ports.
Table 13 USG2200-VPN/USG2200 Front Panel Ports
LABEL DESCRIPTION
RESET Press the button in for about 5 seconds (or until the SYS LED starts to blink), then release it to
return the Zyxel Device to the factory defaults (password is 1234, LAN IP address 192.168.1.1
etc.)
BUZZER RESET The buzzer alarms when a power module fails. Use this to mute the buzzer alarm.
Table 11 USG2200-VPN/USG2200 LED Descriptions (continued)
LED COLOR STATUS DESCRIPTION
To Next Page
Loading...
