ZyXEL Communications USG60W - Page 896

Chapter 43 Object
ZyWALL USG Series User’s Guide
896
Figure 623 Configuration > Object > ISP Account > Edit
The following table describes the labels in this screen.
Table 355 Configuration > Object > ISP Account > Edit
LABEL DESCRIPTION
Profile Name This field is read-only if you are editing an existing account. Type in the profile name of the ISP
account. The profile name is used to refer to the ISP account. You may use 1-31 alphanumeric
characters, underscores(
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
Protocol This field is read-only if you are editing an existing account. Select the protocol used by the ISP
account. Your ISP will provide you with a related username, password and IP (server)
information. Options are:
pppoe - This ISP account uses the PPPoE protocol.
pptp - This ISP account uses the PPTP protocol.
l2tp - This ISP account uses the L2TP protocol.
Authentication
Type
Use the drop-down list box to select an authentication protocol for outgoing calls. Options are:
CHAP/PAP - Your Zyxel Device accepts either CHAP or PAP when requested by this remote
node.
Chap - Your Zyxel Device accepts CHAP only.
PAP - Your Zyxel Device accepts PAP only.
MSCHAP - Your Zyxel Device accepts MSCHAP only.
MSCHAP-V2 - Your Zyxel Device accepts MSCHAP-V2 only.
Encryption
Method
This field is available if this ISP account uses the PPTP protocol. Use the drop-down list box to
select the type of Microsoft Point-to-Point Encryption (MPPE). Options are:
nomppe - This ISP account does not use MPPE.
mppe-40 - This ISP account uses 40-bit MPPE.
mppe-128 - This ISP account uses 128-bit MMPE.
User Name Type the user name given to you by your ISP.
Password Type the password associated with the user name above. The password can only consist of
alphanumeric characters (A-Z, a-z, 0-9). This field can be blank.
Retype to
Confirm
Type your password again to make sure that you have entered is correctly.
IP Address/FQDN Enter the IP address or Fully-Qualified Domain Name (FQDN) of the PPTP or L2TP server.