Chapter 7 Wireless
VMG1312-Bx0D User’s Guide
102
7.8 The Channel Status Screen
Use the Channel Status screen to scan wireless LAN channel noises and view the results. Click
Network Setting > Wireless > Channel Status. The screen appears as shown. Click Scan to
scan the wireless LAN channels. You can view the results in the Channel Scan Result section.
Note: The Scan button only works when the VMG uses 20MHz for the wireless channel
width. You can go to the
Network Setting > Wireless > General screen, click the
more link, and then change the channel width setting in the Bandwidth field.
OBSS
Coexistence
Select Enable to allow the coexistence of 20 MHz and 40 MHz Overlapping Basic Service
Sets (OBSS) in wireless local area networks. Select Disabled to disable this feature.
XPress
TM
Technology
Select Enable for higher speeds, especially if you have both IEEE 802.11b and IEEE
802.11g wireless clients. The wireless clients do not have to support XPress™ Technology,
although the performance enhancement is greater if they do. Select Disabled to disable
this feature.
WPS 2.0 Select Enable to support WPS 2.0 which enhances WPS security and flexibility on
configuration. Select Disabled to disable this feature.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
Table 26 Network Setting > Wireless > Others (continued)
LABEL DESCRIPTION
To Next Page
Loading...
