ZyXEL Communications VMG1312-BX0D - More Secure (WPA(2)-PSK)

Chapter 7 Wireless
VMG1312-Bx0D User’s Guide
92
Figure 35 Wireless > General: Basic (WEP)
The following table describes the labels in this screen.
7.2.3 More Secure (WPA(2)-PSK)
The WPA-PSK security mode provides both improved data encryption and user authentication over
WEP. Using a Pre-Shared Key (PSK), both the VMG and the connecting client share a common
password in order to validate the connection. This type of encryption, while robust, is not as strong
as WPA, WPA2 or even WPA2-PSK. The WPA2-PSK security mode is a newer, more robust version of
the WPA encryption standard. It offers slightly better security, although the use of PSK makes it
less robust than it could be.
Click Network Setting > Wireless to display the General screen. Select More Secure as the
security level.
Table 19 Wireless > General: Basic (WEP)
LABEL DESCRIPTION
Security Level Select Basic to enable WEP data encryption.
Security Mode This shows WEP when you set Security Level to Basic.
Generate
password
automatically
Select this option to have the VMG automatically generate a password. The password field
will not be configurable when you select this option.
Password 1~4 The password (WEP keys) are used to encrypt data. Both the VMG and the wireless stations
must use the same password (WEP key) for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal characters
("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
You must configure at least one password, only one password can be activated at any one
time.
Select password unmask to display the entered password in plain text. Clear it to hide the
password to avoid shoulder surfing.
more.../hide Click more... to show more fields in this section. Click hide to hide them.
WEP Encryption Select 64-bit or 128-bit.
This dictates the length of the security key that the network is going to use.