Chapter 11 Network Address Translation (NAT)
VMG1312-Bx0D User’s Guide
168
Figure 88 Address Mapping: Add/Edit
The following table describes the fields in this screen.
11.8 The Sessions Screen
Use this screen to limit the number of concurrent NAT sessions a client can use. Click Network
Setting > NAT > Sessions to display the following screen.
Table 64 Address Mapping: Add/Edit
LABEL DESCRIPTION
Rule Name Type up to 20 alphanumberic characters for the name of this rule.
Type Choose the IP/port mapping type from one of the following.
One-to-One: This mode maps one local IP address to one global IP address. Note that port
numbers do not change for the One-to-one NAT mapping type.
Many-to-One: This mode maps multiple local IP addresses to one global IP address. This is
equivalent to SUA (i.e., PAT, port address translation), the VMG's Single User Account
feature that previous routers supported only.
Many-to-Many: This mode maps multiple local IP addresses to shared global IP addresses.
Local Start IP
Enter the starting Inside Local IP Address (ILA).
Local End IP Enter the ending Inside Local IP Address (ILA). If the rule is for all local IP addresses, then
this field displays 0.0.0.0 as the Local Start IP address and 255.255.255.255 as the Local
End IP address. This field is blank for One-to-One mapping types.
Global Start IP Enter the starting Inside Global IP Address (IGA). Enter 0.0.0.0 here if you have a dynamic
IP address from your ISP. You can only do this for the Many-to-One mapping type.
Global End IP Enter the ending Inside Global IP Address (IGA). This field is blank for One-to-One and
Many-to-One mapping types.
WAN Interface Select a WAN interface to which the address mapping rule applies.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
