Chapter 1 Introducing the VMG
VMG1312-Bx0D User’s Guide
20
None of the LEDs are on if the VMG is not receiving power.
1.7 The RESET Button
If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the password will be reset to “1234”.
1 Make sure the POWER LED is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button for ten seconds or
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink,
the defaults have been restored and the device restarts.
Table 1 LED Descriptions
LED COLOR STATUS DESCRIPTION
POWER
Green On The VMG is receiving power and ready for use.
Blinking The VMG is self-testing.
Red On The VMG detected an error while self-testing, or there is a device
malfunction.
Off The VMG is not receiving power.
DSL
Green
On The DSL line is up.
Blinking The VMG is initializing the DSL line.
Off The DSL line is down.
INTERNET
Green On The VMG has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a DHCP
server), PPP negotiation was successfully completed (if used) and the
DSL connection is up.
Blinking The VMG is sending or receiving IP traffic.
Off There is no Internet connection or the gateway is in bridged mode.
Red On The VMG attempted to make an IP connection but failed. Possible
causes are no response from a DHCP server, no PPPoE response, PPPoE
authentication failed.
ETHERNET1
~4
Green On The VMG has a successful 10/100 Mbps Ethernet connection with a
device on the Local Area Network (LAN).
Blinking The VMG is sending or receiving data to/from the LAN at 10/100 Mbps.
Off The VMG does not have an Ethernet connection with the LAN.
WLAN/WPS
Green On The wireless network is activated.
Blinking The VMG is communicating with wireless clients.
Orange Blinking The VMG is setting up a WPS connection with a wireless client.
Off The wireless network is not activated.
USB
Green On The VMG recognizes a USB connection through the USB slot.
Blinking The VMG is sending/receiving data to/from the USB device connected to
it.
Off The VMG does not detect a USB connection through the USB slot.
To Next Page
Loading...
