Chapter 6 Broadband
VMG1312-Bx0D User’s Guide
69
6.2.1.2 Bridge Mode
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon
next to the connection you want to configure. Select Bridge as the encapsulation mode. The screen
varies depending on the interface type you select.
If you select ADSL/VDSL over PTM or Ethernet as the interface type, the following screen
appears.
Figure 24 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL/VDSL over PTM -
Bridge Mode)
The following table describes the fields in this screen.
Table 9 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL/VDSL over PTM -
Bridge or Ethernet Mode)
LABEL DESCRIPTION
General
Name Enter a service name of the connection.
Type Select ADSL/VDSL over PTM as the interface that you want to configure. The VMG uses the
VDSL technology for data transmission over the DSL port.
Mode Select Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP’s DHCP server directly. If you select
Bridge, you cannot use routing functions, such as QoS, Firewall, DHCP server and NAT on
traffic from the selected LAN port(s).
VLAN This section is available only when you select ADSL/VDSL over PTM in the Type field.
Active Select the checkbox to enable VLAN on this WAN interface.
802.1p IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame
that contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The
greater the number, the higher the priority level.
To Next Page
Loading...
