Chapter 6 Broadband
VMG1312-Bx0D User’s Guide
81
6.6.1 Modify 802.1X Settings
Use this screen to edit 802.1X authentication settings. Click the Edit icon next to the rule you want
to edit. The screen shown next appears.
Figure 31 Network Setting > Broadband > 802.1x > Modify
The following table describes the labels in this screen.
6.7 Technical Reference
The following section contains additional technical information about the VMG features described in
this chapter.
Encapsulation
Be sure to use the encapsulation method required by your ISP. The VMG can work in bridge mode
or routing mode. When the VMG is in routing mode, it supports the following methods.
Table 16 Network Setting > Broadband > 802.1x: Edit
LABEL DESCRIPTION
Active This field allows you to activate/deactivate the authentication.
Select the checkbox to enable the authentication. Clear this to disable this authentication
without having to delete the entry.
Interface Select an interface to which the authentication applies.
EAP Identity Enter the EAP identity of the authentication.
EAP method This is the EAP method used for this authentication.
Bidirectional
Authentication
Select the checkbox to allow bidirectional authentication.
Certificate Select the certificate you want to assign to the authentication. You need to import the
certificate in the Security > Certificates > Local Certificates screen.
Trusted CA Select the Trusted CA you want to assign to the authentication. You need to import the
certificate in the Security > Certificates > Trusted CA screen.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
