ZyXEL Communications VMG1312-BX0D - Page 194

Chapter 16 Firewall
VMG1312-Bx0D User’s Guide
194
Figure 112 Access Control: Add/Edit
The following table describes the labels in this screen.
Table 83 Access Control: Add/Edit
LABEL DESCRIPTION
Filter Name Enter a descriptive name of up to 16 alphanumeric characters, not including spaces,
underscores, and dashes.
You must enter the filter name to add an ACL rule. This field is read-only if you are editing
the ACL rule.
Order Select the order of the ACL rule.
Select Source
Device
Select the source device to which the ACL rule applies. If you select Specific IP Address,
enter the source IP address in the field below.
Source IP
Address
Enter the source IP address.
Select
Destination
Device
Select the destination device to which the ACL rule applies. If you select Specific IP
Address, enter the destiniation IP address in the field below.
Destination IP
Address
Enter the destination IP address.
IP Type Select whether your IP type is IPv4 or IPv6.
Select Service Select the service rule that defines your customized port from the drop-down list box. The
specific service rule you add in the Security > Firewall > Protocol screen display in this
list.
If you want to configure a customized service, select Specific Service.