Chapter 17 MAC Filter
VMG1312-Bx0D User’s Guide
197
The following table describes the labels in this screen.
Table 85 Security > MAC Filter
LABEL DESCRIPTION
MAC Address Filter Select Enable to activate the MAC filter function.
MAC Restrict Mode Select Allow to only permit the listed MAC addresses access to the VMG. Select Deny
to permit anyone access to the VMG except the listed MAC addresses.
Set This is the index number of the MAC address.
Active Select Active to enable the MAC filter rule. The rule will not be applied if Active is not
selected.
Host Name Enter the host name of the wireless or LAN clients that are allowed access to the VMG.
MAC Address Enter the MAC addresses of the wireless or LAN clients that are allowed access to the
VMG in these address fields. Enter the MAC addresses in a valid MAC address format,
that is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
