Chapter 7 Wireless
VMG3926-B10A User’s Guide
100
7.6 The WDS Screen
An AP using the Wireless Distribution System (WDS) can function as a wireless network bridge
allowing you to wirelessly connect two wired network segments. The WDS screen allows you to
configure the VMG to connect to two or more APs wirelessly when WDS is enabled.
Use this screen to set up your WDS (Wireless Distribution System) links between the VMG and
other wireless APs. You need to know the MAC address of the peer device. Once the security
settings of peer sides match one another, the connection between devices is made.
Note: WDS security is independent of the security settings between the VMG and any
wireless clients.
Note: At the time of writing, WDS is compatible with other ZyXEL APs only. Not all models
support WDS links. Check your other AP’s documentation.
Click Network Setting > Wireless > WDS. The following screen displays.
Figure 38 Network Setting > Wireless > WDS
The following table describes the labels in this screen.
Table 24 Network Setting > Wireless > WDS
LABEL DESCRIPTION
2.4GHz Wireless Bridge Setup
AP Mode Select the operating mode for your VMG.
• Access Point - The VMG functions as a bridge and access point simultaneously.
• Wireless Bridge - The VMG acts as a wireless network bridge and establishes wireless
links with other APs. In this mode, clients cannot connect to the VMG wirelessly.
Bridge Restrict This field is available only when you set operating mode to Access Point.
Select Enabled to turn on WDS and enter the peer device’s MAC address manually in the
table below. Select Disable to turn off WDS.
Remote Bridge
MAC Address
You can enter the MAC address of the peer device by clicking the Edit icon under Modify.
# This is the index number of the entry.
To Next Page
Loading...
